Autopilots
The Piccolo LT
is a full featured Piccolo version that is applicable for the smallest electric UAVs or other applications where size and cost are a primary consideration.
- Despite small size, includes all sensors, 4 Hz GPS, and integrated radio link.
- Thin form factor is ideal for small flying wing applications.
- EMI Shielded carbon fiber enclosure.
- Single 37-pin vehicle interface micro-D connector.
- Same firmware and software as other Piccolo options.
Mechanical |
|
 Size: |
5.1 inches x 2.34 inches x 0.76 inches |
| Weight: |
45 grams (1.6 oz) w/o radio and enclosure |
Environmental |
|
| Operating Temperature: -40C to +80C (Calibrated Range) |
|
Interface |
|
| Serial interface: |
Two RS232 payload ports |
| Servo PWM: |
6 servos |
| CAN: |
Simulation Interface |
| General Purpose: |
1 GPIO line |
| Flight Termination: |
Deadman output |
Electrical |
|
| Power: |
4.8 V to 24 VDC, 5 W max |
The Piccolo avionics and Ground Station radios must be configured with the same radio. The 900 MHz ISM radio is an unlicensed radio in North America. Cloud Cap Technology recommends this radio option for North American customers not requiring DoD licensed bands.
Download the DD1494 forms for Cloud Cap Technology’s radio spectrum-dependent equipment.
Available Radio Options:
- 900 MHz Unlicensed ISM*
* The 900 MHz Unlicensed ISM is the only radio option available for the Piccolo LT.
Download the DD1494 forms for Cloud Cap Technology’s radio spectrum-dependent equipment.
Advanced Software Features
The Piccolo LT comes with the Economy Feature Set at no additional charge. The following additional software feature sets can be purchased:
- Standard Software Feature Set
- Laser Altimeter Autoland
- DGPS Autoland
- DGPS and Moving Net Recovery
- VTOL Vehicle Support
View a comparison table of all the software features available for the Piccolo II Autopilot.
Download the Piccolo Software Options Data Sheet for complete information.
- CCT Part No. 200-00500-00
- CCT Part No. 500-00252-00
- CCT Part No. 500-00259-00
- CCT Part No. 500-00257-00
- CCT Part No. 500-00260-00
- CCT Part No. 500-00261-00
- CCT Part No. 500-00303-00
- CCT Part No. 500-00639-00
- CCT Part No. 500-01152-0
- CCT Part No. 500-00639-00
- CCT Part No. 900-00317-00
- CCT Part No. 900-00317-00
Piccolo LT Developer’s Kit
CCT Part Number 900-90018-00
- CCT Product Catalog - A short developmental history of the Piccolo autopilot.
- Complete Product List - A complete list of integration, peripherals, and accessory items designed to optimize CCT products and systems.
- Product Export Fact Sheet - A brief description of the regulatory processes required for Cloud Cap Technology to export its products.
- Piccolo System History - A short developmental history of the Piccolo Autopilot.
- Steps to Autonomous Flight - Outlines the steps involved in configuring, installing and operating the Piccolo autopilot system. It is very important to read this document first because it provides a guide through other system documentation required to properly set up and integrate the Piccolo system.
- Piccolo Setup Guide - An overview of the Piccolo autopilot system components. Provides initial setup information for the hardware and software simulation environments to guide users to a functioning laboratory environment.
- SIL and HIL Checklists – A quick reference checklist for the Software-in-the-Loop and Hardware-in-the-Loop simulations.
- Piccolo User's Guide (v1.3.2) - Provides a basic description, interface guidelines, and setup information for the Piccolo autopilot system using version 1.3.2 software.
- Piccolo User's Guide (v2.0.4) - Provides a basic description, interface guidelines, and setup information for the Piccolo autopilot system using version 2.0.4 software.
- Piccolo User’s Guide (v2.1.0) - Provides a basic description, interface guidelines, and setup information for the Piccolo autopilot system using version 2.1.0 software.
- Piccolo User’s Guide Helicopter Supplement – Provides controller information and swashplate configurations for the Piccolo autopilot system used in helicopter and other rotary wing unmanned vehicle applications.
- Piccolo Simulator -A detailed user’s guide to the Simulator environment and software. Includes guidance on modeling and simulating customer aircraft which is a key element in the steps to autonomous flight.
- Piccolo External Interface - Interface definitions and pin-outs for the Piccolo Plus, Piccolo II, and Piccolo LT.
- Piccolo Dev Interface - A quick introduction guide to the Piccolo Dev Interface application that provides tools useful for system data analysis.
- Communications Troubleshooting - Covers basic testing procedures, information, and tools to help diagnose Piccolo radio communication problems.
- Piccolo Software Update Guide - Covers how to update Cloud Cap Technology products with the latest software and firmware.
- Software Roadmap - Outlines the development plan for maintenance of the Piccolo software.
- Piccolo Software-in-Loop Setup Guide - A comprehensive step by step guide to set up the Software-in-Loop (SIL) simulation environment.
- OAT Sensor External Interface - Interface definitions and pin-outs for Outside Air Temperature Sensor.
- Piccolo Vehicle Integration Guide - Provides technical information for installing the Piccolo autopilot into an airframe.
- Iridium Integration Guide - Provides technical information for installing the Iridium communication system into an airframe.
- Magnetometer Integration Guide - Provides technical information for integrating a Magnetometer with a Piccolo autopilot.
- Novatel DGPS Integration Guide –Provides technical information needed to assist in the integration of the Novatel DGPS equipment with the Piccolo Autopilot system avionics and Piccolo Portable Ground Station.
- Tach / Deadman Integration Guide - Provides technical information for installing the Tach/Deadman interface board.
- Piccolo Servo Gimbal Integration Guide – How to setup and configure a non-stabilized, servo based gimbal–other than a Cloud Cap Technology gimbal–to the Piccolo autopilot using the pan and tilt servo connections available on the Piccolo autopilot.
- Piccolo Preflight Checklist - Lists important preflight checks for the Piccolo autopilot system.
- Flight Summary Log Sheet - Used for documenting important pre and post flight information in Microsoft Word and Adobe PDF format.
- Using Validate During Preflight - Describes procedures on how to validate current Piccolo parameters against a file of known correct parameters.
- Piccolo Bench Interface Cable Reference Schematic - Cable is included with the Piccolo Developer’s Kit. Provides power, CAN, serial and programming interfaces needed for laboratory setups including HWIL.
- Piccolo Typical Flight Harness Schematic – Basic harness that includes control surface outputs as well as power, CAN, serial and programming interfaces needed for aircraft integration.
- Pilot Console Cable Schematic - Old Style - Connects the DIN connector trainer port on older (6 and 8 channel) Futaba pilot consoles to the Piccolo Desk Top Ground Station.
- Pilot Console Cable Schematic - New Style - Connects the small square 6 pin connector trainer port on newer (9 channel) Futaba pilot consoles to the Piccolo Desk Top Ground Station.
- UHF Antenna Trim Charts - Avionics and GS - Provides specifications for the ground station and avionics UHF antenna.
- RF Spectrum Information – DD-1494 Information for all Piccolo system intentional RF radiators.
- Piccolo II Assembly Drawing – A dimensional drawing of the Piccolo II Autopilot.
- Latest Piccolo Release - Includes all the Piccolo software applications, installers and related support documentation.
- Aircraft Modeling Tools - Helps to model aircraft dynamics in the Piccolo System. Useful for developing a simulation model of your aircraft.
- Flight Gear - A highly accurate software flight simulator that helps to provide visualization of the aircraft altitude.
- Maps - A collection of various maps layers to use for visualization reference in the Piccolo Command Center and Gimbal UI.
- Piccolo Plus Data Sheet - Specifications and dimensional drawings of the Piccolo Plus autopilot.
- Piccolo II Data Sheet -Specifications and dimensional drawings of the Piccolo II autopilot.
- Piccolo LT Data Sheet - Specifications and dimensional drawings of the Piccolo LT autopilot.
- Piccolo Command Center Data Sheet - Defines the PCC performance features that require a purchased license solution.
- Piccolo Autopilot Family - Comparison of specifications for the Piccolo family of autopilots.
- Piccolo Autopilot Software Options – A list of software feature sets that are available for each autopilot.
- Piccolo System - Component Weights – Useful for aircraft integrators, lists Piccolo System components and weights.
- Power Regulator Board Data Sheet - Specifications and dimensional drawings of the Power Regulator Board.
- AGL Sensor Datasheet - Specifications and dimensional drawings of the AGL Sensor.
- Pitot / Static Combined Data Sheet - Specifications and dimensional drawings of the combined Pitot / Static assembly.
- Pitot / Static Tubes Data Sheet - Specifications and dimensional drawings of the Pitot and Static tubes.
- All Piccolo Autopilots can be configured for Laser Altimeter or DGPS auto landings, and moving net recovery.
- Piccolo testing and demonstration video may also be downloaded and viewed in WMV format from our Video Downloads page
Join our list
if you would like to be notified of the latest product updates - software update notices, critical faults, software bugs and procedure updates.
You can also visit our Downloads page to get the latest software updates, product documentation, drawings, videos and other useful CCT tools and information.
View the product update history |
Need help building a full avionics solution? Use the Piccolo Configuration Wizard. |
© Cloud Cap Technology, a Goodrich Company. All rights reserved.
Directions to our office, map and local accommodations.
Web: Gorge Web Design Site Map Privacy
